The study of wood as a renewable material and organic material is what is known as wood science. In other words, the term wood science can also be known as wood technology. Wood is treated as a material in direct comparison with other products. The comparison made against other products will include the features of the material against those of wood, the value and the ease it can be worked on. The many Merits of timber and these technologies improve wood to be superior over other products. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. Wood is renewable, and this makes it more precious. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.
The good appearance of your timber made structure cannot be guaranteed if protection of the timber is not done. Wooden structures have to be kept away from water and pests that eat through the wood. The water particles in the timber increase the rotting and the insects bore through the wood. Many methods are available in the treatment of wood one of the most common being the ACQ – alkaline copper Quaternary. This is a copper-based preservative that is applied to the wood for protection. There are a few disadvantages of this method as a mode of wood preservation. It has been seen corroding most metals for example aluminum in less than six months of its application. The saturation level of any treatment will depend on where the wood is going to be used and the species of the wood. Timber being used around a water body will be dipped in a more saturated fluid than that being used above ground.
The use of copper metal is another method of wood treatment that is fast being accepted. The use of this method is fast being accepted because it is not corroding the metal fasteners. Micronized copper wood preservative is the correct term to refer this type of preservation. The copper metal is applied to the wood as small microscopic particles injected into the wood at high pressure. In other copper-based preservation methods copper is dissolved in chemicals while in this method copper is driven into the wood as a metal. This process is highly effective and the wood properties and heightened. The timber treated in this way is used in both outdoor and indoor frames that last very long.
Termites cannot eat through timber treated through this method. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. The wood treated using this method last longer and is stronger.